Saturday, October 11, 2008

Engine Bay Prep


All of the battery racks are finally complete. After a good coat of rubberized undercoating, they are ready to install.

I have used the last of my rattle-can red to paint the remainder of the engine bay. Then, while I still had good access to the engine bay, I decided to fashion a plate to block air from coming through the grill. This is a measure to improve the aerodynamic profile of the car.

I just happened to have some thin aluminum sheet that was removed from another car project. Working outside on a nice day using a few simple tools, I made a pretty nice little block-off plate.

No comments: